@Machine Type@F@xaAaAmAmkAkgAfmAfa
 |
 |
 |
| @ Remove the cooling water tube. |
A Remove the lead wire. |
B Pull out the seal bar mounting pin and remove the seal bar. |
 |
 |
 |
| C Take off the cover tape. |
D Loosen 2 of the seal wire tightening bolts on both ends. |
E Take off the old seal wire. |
 |
 |
 |
| F Clean and wipe the dirt on the base tape. |
G Cut a new seal wire in length of 5 cm longer than seal bar. |
H Set the seal wire in a sealing wire tightening plate on one end and strain the wire in straight. |
 |
 |
 |
| I Set the other side of the wire in the sealing wire tightening plate. Pull the wire by handle with making sure the wire set onto the center of seal bar. |
J Excess of the wire should be cut off. |
K Set the new cover tape. |
 |
 |
 |
| L In order to avoid take-off of tape on bending pats on seal bar, cut the tape at the necessary points and put the tape smoothly on the seal bar. |
||